Broilmaster PCB1-2 Manuel d'utilisateur télécharger pdf (Page 10)

B101586-4-0112Page 10

9. For Grill Heads other than R3 Series, continue on to Step 10.

For R3 Series Grill Heads: Press in the two sides of the

Control Housing (provided with Grill Head) and t it into the

opening under the grill head as shown in Figure 10. Grill

Assembly will look like Figure 11.

Note: It may be easier to insert one side of the control housing

rst, and then press in the other side using the cart as a brace

for the inserted side.

Figure 10

Figure 11

CArt ASSEmbly

10. Mount the tank retainer to the cart by using 1/4-20 x 1 1/4 Phil-

lips Truss Head screw and 1/4-20 wing nut.

Figure 12

10. Install Grease Cup by sliding it in the cutout provided in the

shield.

Figure 13

11. For Stationary Cart Assembly: Slide grill assembly into posi-

tion over holes drilled in Step 1. Secure with three screws (not

supplied). If applicable, route the gas line through the hole and

attach to the grill.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Broilmaster PCB1-2 Manuel d'utilisateur Page 10